POLYMERA® MS FLUID MS Polymer Based Fluid Liquid Membrane
 

Description:
Single component, fluid, ready-to-use, high technology coating and waterproofing material. It does not contain solvent and isocyanate. It is produced with MS Polymer Hybrid Technology and is resistant to UV.

 

POLYMERA MS FLUID can be used for waterproofing of horizontal and vertical large
surfaces and for bridging capillary cracks up to 3 mm.

 

Application Areas:
• Indoor and outdoor
• Waterproofing and local repairs of horizontal surfaces, thanks to its self levelling properties
• Waterproofing and local repair of vertical surfaces, thanks to its ease of application with roller or brush
• All kinds of mineral surfaces such as concrete, stone, marble, ceramic, tiles, woods, glass, metals, roof tile, brick, cement mixed chip panel, gas concrete etc. and combination of all of these
• Balconies, terraces or inclined roofs where waterproofing is required, on wood and metal surfaces, in intersections of chimneys, ventilations and skylights
• Potable water tanks, pools and cisterns
• Wet areas such as bathrooms and kitchens
• Places below ground level, such as foundation, garage and basement, against non- pressurized water and ground moisture.

 

Advantages:
POLYMERA MS FLUID is MS Polymer based product, which has high technical properties, developed with Japanese technology. MS Polymer technology has important advantages
compared to existing polyurethane, silicone, bitumen or cement-acrylic based coatings:
• Does not contain solvent and isocyanate which are harmful to human health and to the
environment. Can be safely used indoor and in contact with the potable water
• Has 100% elastomeric composition, does not shrink as it does not contain solvent
• Resistant to UV, does not crack, sag or turn to yellow. Can be safely used outdoor
• Bonds even on damp surfaces without primer, provides high adherence. Bonds on wet
surfaces with a primer
• Not harmful to human health and to the environment thanks to its low VOC values. Almost
odorless
• Easily and quickly applied with a brush or a roller. Does not form seams. Overpaintable
• Very flexible. Can bridge the cracks up to 3 mm, fill the cracks up to 2 mm. Keeps its
elasticity and bonding properties in joints and cracks formed due to the movements of the buildings. Turns to its original form perfectly
• Protects its elasticity even in low temperatures, after being cured. POLYMERA MS FLUID is a new generation product which offers all these advantages in a single product.

Consumption: 1.40 - 1.50 kg/m2 for approximately 1 mm thickness in each layer. (Varies depending on the application area, roughness and absorption of the surface.) At least two layers are recommended.
Packaging: 1 kg tin cans 7 kg plastic buckets (7 kg aluminum foiled package) 14 kg plastic buckets (2 x 7 kg aluminum foiled packages

 

Technical Properties
Appearance : Medium visc. elastomeric fluid liquid coating
Color : RAL colours
Density : 1.45 ± 0.05 kg/L
Application Temperature : Between +5°C and +35°C
Hardness (Shore A) : 35 ± 5
Bond Strength by Pull-off: ≥ 2.0 MPa (EN 1542)
Elongation at Break : > 300% (7 days)
Capillary Absorption and : w < 0.1 kg/(m2 .h0.5) (EN 1062-3);
Water Permeability 0.018 kg/(m2 .h0.5) (TS 4045)
Film Formation Time : 150 ± 30 minutes
Curing Rate : 2 mm / 24 hours
Service Temperature : -30°C / +80°C